PANEL LIGHT  INDICATORS

A snap-in panel lamp holder using a replaceable (BA7) 12 volt bulb. Flat lens that protrudes only 13/64" from panel for a near flush installation. Snaps into .5” dia. hole in panels up to 13/32“ thick. May be soldered or use .250 tabs.

 (LAMP NOT INCLUDED)

Jumbo size panel lamp holder with 1" lens for high visibility. Accepts T-3¼ miniature bayonet base bulbs. Lamp replaceable from rear or with extractor from front. Chrome bezel. Mounts in 1" dia. mounting hole in panels up to .334" thick. Tab terminals for .250" quick connectors or may be soldered.

Large size panel lamp holder for T-3¾ miniature bayonet base bulbs. Chrome bezel. Mounts in ¾" dia. hole in panels up to ¼" thick. Lamp replaceable from rear or with extractor from front. Tab terminals for .250" quick connectors or may be soldered.

A small attractive panel lamp that accepts single contact T-¼ midget flange base bulbs (381 382, 387). Nylon threaded body mounts .5" dia. hole in panels up to .38" thick. Solder terminals.

12-volt built-in (non-replaceable) incandescent panel lamp with chrome bezel for attractive panel design. Mounts in ¼" diameter mounting hole in panels up to ¼" thick. 5" PVC wire leads.

A jumbo size indicator light with a 27/32" round lens with high visibility. Snaps into a 1" diameter hole in panels from 1/32" to 3/32" thick. Tab terminals for .250" quick connectors or may be soldered.

Large diameter (19/32") full view indicator gives maximum visibility from any angle. Lens sets on a chrome bezel and protrudes 11/32" in-front of mounting surface. 12 volt non-replaceable long-life lamp. Nylon threaded body mounts into ½" diameter mounting hole in panels up to 37/64" thick. PVC insulated 5" wire leads.

A full view 12 volt indicator that snaps into a 5/16" diameter mounting hole in panels from 1/32" to 3/32" thick. Contains a 12/14 volt non-replaceable long-life lamp. 5" PVC insulated wire leads.

LINK FOR AVAILABLE INDICATORS